A Correction Strategy for Instrument Drift and Tides
The result of the drift and the tidal portions of
our gravity observations is that repeated observations at one location yield different values for the
gravitational acceleration.
The key to making effective corrections for these factors is to note that both alter the observed
gravity field as slowly varying functions of time.
One possible way of accounting for the tidal component of the gravity field would be to establish a
base station* near the survey area, and continuously monitor the gravity field at this location while
other gravity observations are being collected in the survey area. This would result in a record of the
time variation of the tidal components of the gravity field that could be used to correct the survey
observations.
*Base Station - A reference station that is used to establish additional stations in relation thereto.
Quantities under investigation have values at the base station that are known (or assumed to be known)
accurately. Data from the base station may be used to normalize data from other stations.**
This procedure is rarely used for a number of reasons.
- It requires the use of two gravimeters. For many gravity surveys, this
is economically unfeasable.
- The use of two instruments requires the mobilization of two field crews, again adding to the cost of the
survey.
- Most importantly, although this technique can be used to remove the tidal component, it will not remove
instrument drift. Because two different instruments are being used they will exhibit different drift
characteristics. Thus, an additional drift correction would have to be performed.
Since, as we will show below, this correction can also be used to eliminate earth tides, there is no
reason to incur the extra costs associated with operating two instruments in the field.
Instead of continuously monitoring the gravity field at the base station, it is more common to
periodically reoccupy (return to) the base station.
This procedure has the advantage of requiring only one gravimeter to measure both the time variable
component of the gravity field and the spatially variable component.
Also, because a single gravimeter is used, corrections for tidal variations and instrument drift
can be combined.
Shown above is an enlargement of the tidal data set shown previously.
Notice that because the tidal and drift components vary slowly with time, we can approximate these components
as a series of straight lines. One such possible approximation is shown below as the series of green lines.
The only observations needed to define each line segment are gravity observations at each end point, four
points in this case.
Thus, instead of continuously monitoring the tidal and drift components, we could intermittantly measure them.
From these intermittant observations, we could then assume that the tidal and drift components of the field
varied linearly (that is, are defined as straight lines) between observation points, and predict the
time-varying components of the gravity field at any time.
For this method to be successful, it is vitally important that the time interval used to intermittantly measure
the tidal and drift components not be too large. In other words, the straight-line segments used to estimate
these components must be relatively short. If they are too large, we will get inaccurate estimates of the temporal
variability of the tides and instrument drift.
For example, assume that instead of using the green lines to estimate the tidal and drift components we could use
the longer line segments shown in blue.
Obviously, the blue line is a poor approximation to the time-varying components of the gravity field.
If we were to use it, we would incorrectly account for the tidal and drift components of the field. Furthermore,
because we only estimate these components intermittantly (that is at the end points of the blue line) we
would never know we had incorrectly accounted for these components.
**Definition from the Encyclopedic Dictionary of Exploration Geophysics by R. E. Sheriff,
published by the Society of Exploration
Geophysics.